And the reality, the stark reality of what’s going on in Ukraine, is harrowing,” he told Politico in February. “One is really a fairy tale for children, originally that’s what Star Wars was. In previous interviews regarding his support for Ukraine, Hamill has sought to distinguish his movies from the real-life situation in Ukraine. One fan wrote on Twitter that his voice “ cheers me up.” Another said, “It’s such a little thing, but it keeps our spirits up and helps handle stress from almost daily air raid sirens.”Īir raid alarms, such as the one voiced by Hamill, have sounded more than 19,000 times in one year of the war, the Associated Press said. The good-versus-evil theme of Star Wars, Hamill told the Associated Press, is similar to the battle Ukraine is fighting for its future: “The Ukrainian people rallying to the cause and responding so heroically … it’s impossible not to be inspired by how they’ve weathered this storm,” he said.įor some in Ukraine, Hamill’s voice is a balm during difficult moments. The “Dronation” campaign (tagline: “These are the drones you’re looking for”) helped fund 1,400 drones in three months, according to the campaign website. Last year, he was named ambassador for an initiative set up by the Ukrainian armed forces to raise money for drones to combat Russian aggression. Hamill is one of the many Hollywood celebrities to contribute to aid and humanitarian efforts in Ukraine. If the output of the above CLI command still shows it 'Recondition' or 'bad' Please request for the level 1 diag data and escalate the case.Actor Mark Hamill arrives at the 2019 world premiere of “Star Wars: The Rise of Skywalker” in Los Angeles. Request the output of the following commands again and if it is as follows CLI> stat get raid.cache1on Note: it will take approximately 24-36 hours before it is showing the status charged. Some older Mirapoint systems do not support these battery commands. Is a battery number, which can be determined with Storage Get Bbstatus. There are different RAID levels, however, and not all have the goal of providing redundancy. Where action is either Startcalibration or Stopcalibration and battnum RAID (redundant array of independent disks) is a way of storing the same data in different places on multiple hard disks or solid-state drives (SSDs) to protect data in the case of a drive failure. Use this command to stop calibration at peak hours Module) is removed to replace a failed fan, the RAID controller losesīattery calibration. There's a cli command to start the recondition for the Battery >storage battery startcalibration 0įor more information you can refer this cLI command > help storage battery startcalibration RAID.BATTERY1STATUS: 'Recondition Needed' What does this alert mean? The following conditions are outstanding: if the alert continues please contact Mirapoint Support for a battery replacement. If the alert persists then it means the battery id reaching EOL and needs to be replaced.

So, system performance will be slow during this process. Once the Battery reconditioning cycle is complete, RAID.CACHEON alerts will stop automatically.Ģ. In this mode, data will be directly written to the RAID subsystem (disks), not making use of the RAID cache. During this cycle, the RAID controller will be put in write-through mode, causing RAID.CACHEON alerts. This reconditioning cycle takes from 24 to 36 hours to complete.

The battery went through its maintenance cycle, this means a discharge and then controlled recharge to test the condition of the battery. System performance will be slow.) indicates 2 conditions with the onboard RAID write-cache battery:ġ. The alert (RAID.CACHE1ON: Raid controller cache is in write-through mode. RAID.CACHE1ON: Raid controller cache is in write-through mode. Contact Mirapoint support for a replacement. The following conditions are outstanding: RAID.BATTERY1STATUS: Raid controller battery is Bad or Missing.

Raid alert in macungie